Successful Load of Current Image with 1 small question

[petestrash]

With GS=0 it should not be booting into maintenance mode still.

So I don't know why it is still doing it.

Just for fun try using the same part of TWP to set PAL guided setup mode, then reboot and confirm you have the same startup screen. then reset to PAL and reboot.

Maybe one of the NZ'ers on here can also confirm the latest NZ image does have 2 different startup screens.

Peter.

[Gazzagazzanz]

OK will do.

The actual maintenance mode screen isn't showing, this one seems to be an intermediary... anyway, I'll report.

With GS=0 it should not be booting into maintenance mode still.

So I don't know why it is still doing it.

Just for fun try using the same part of TWP to set PAL guided setup mode, then reboot and confirm you have the same startup screen. then reset to PAL and reboot.

Maybe one of the NZ'ers on here can also confirm the latest NZ image does have 2 different startup screens.

Peter.

[Darren King]

The actual maintenance mode screen isn't showing

That's what should be happening with GS=0

.... so what is the question/problem again?

[Gazzagazzanz]

There's a screen, that has a Tivo with what looks like a sunset behind, below is a black section, on the left is emblazoned a NZ silver fern, in text on the bottom area it says "Only a few minutes more..." Or similar to this. I need to check he fine details.

I assumed it was indicating the setup process is incomplete...???

That's what should be happening with GS=0

.... so what is the question/problem again?

[Darren King]

Having not seen the particular screen in question as it is a NZ image specific thing, I would be assuming that if this is not the "maintenance mode" screen like you would have witnessed when first setting up your TiVo then like the OzTiVo image there is a "Starting Up" screen which is what this screen you describe sounds like. To further reinforce this the original USA software has a screen saying "Almost there... A few more moments please" (or similar) when it is booting normally too.

If your TiVo is operating normally with no jerky live TV and you have guide data then this is most likely what this screen is.

Maybe one of the NZ guys can comment.

[DJC]

Confrim Darren, this is the NZ image normal startup screen.

(Maintenance mode screen looks the same except it says "Maintenance Mode")

[Darren King]

Thanks for that

[Gazzagazzanz]

Ah, OK, so I was confused then... I was assuming that it was indicating the tivo setup was almost there... maybe the wording could have been chosen slightly better...

Confrim Darren, this is the NZ image normal startup screen.

(Maintenance mode screen looks the same except it says "Maintenance Mode")