Hi!

Just wanted to ask for suggestions on what could be my next step (or I may have missed something really obvious after reading the docs). I got the TiVo off a friend who just upgraded to the new series. First thing I did was upgrade my box to 1.6.2.

I however can't complete set up because the first setup call wont finish. Networking is all fine on the TiVo (ping, dns, wget, turned off firewall on modem/router etc) and I've tried all the transparent proxy changes (even though I don't think I go through one, but hey!) but I still get the same error (in tclient log). The log lines look like:
(I hope these are the relevant lines)

Jan 28 20:41:02 (none) comm[166]: Using Ethernet. Not starting modem/pppd.
Jan 28 20:41:02 (none) comm[166]: CallStatusReporter: Phase: Start_Auth, Status In Progress
Jan 28 20:41:02 (none) comm[166]: CallStatusReporter: sending message "ST|33"
Jan 28 20:41:03 (none) comm[166]: CommUtil: connection to host 65.49.60.197, port 9090, err 0x0
Jan 28 20:41:03 (none) comm[166]: Uploading HTTP Header for modLog of /var/log/svclog: POST /tivo-service/mlog.cgi HTTP/1.0^M Content-Length: 319059^M ^M
Jan 28 20:44:17 (none) comm[166]: XferRqst timeout waiting to read
Jan 28 20:44:17 (none) comm[166]: drainGetPostQ: doXfer failed err=65535 (0xffff)
Jan 28 20:44:17 (none) comm[166]: NetAgent: drainPostQ failed, err = 0xffff

So it is timing out from what I can tell. I've tried connecting through the emuProxyZA as well. I have a turboNet card and use a wireless bridge to connect.

Any suggestions on what to try next or clues as to the problem?

Thanks in advance!