Where are you getting the "loadcodes" command from? It is not necessary.

The codes are currently loaded into your TiVo, but the codes do not appear in the on screen list until you upload them to our server, and I make a new IR slice.

To test them you need to manually tell the TiVo to use the codes you have just loaded into 29992.

Find your current source record, use TivoWeb(or TivoWebPlus), click MFS(or more... then MFS or System... them MFS in TWP) Scroll down the page to "setup" Click setup. Write down the number that appears after "source =", should look a bit like XXXX/YY ( with numbers in place of XXXX & YY and may have more or less digits than the X's and Y's shown).

Then execute the following from Telnet

dbsetx XXXX/YY CableBoxCodeNum 29992

Where XXXX & YY are from your source.

Then reboot to apply.

Once they work for a week or so, upload them to the Database, so others can use them and if you need to start again they are already pre-loaded in the system.

Peter.