I now have the tivo sending IR codes, but not all that much better at the job.



I used the tivo to capture codes, and now I can hit the number pad and something is at least sent to the VCR.



Example:

[TiVo [p0] /hack/guide]# ./lssources

Listing source 2274/12

SignalSource 2274/12 {

CableBoxCodeNum = 10022

Channel = 2274/13 2274/14 2274/15 2274/16 2274/17 2274/18 2274/19 2274/20 2274/21 2274/22 2274/23 2274/24 2274/25 2274/26 2274/27 2274/28 2274/29 2274/30 2274/31 2274/32 2274/33 2274/34 2274/35 2274/36 2274/37 2274/38 2274/39 2274/40 2274/41 2274/42 2274/43 2274/44 2274/45 2274/46 2274/47 2274/48 2274/49 2274/50 2274/51 2274/52 2274/53 2274/54 2274/55 2274/56 2274/57 2274/58 2274/59 2274/60 2274/61 2274/62 2274/63 2274/64 2274/65 2274/66 2274/67 2274/68 2274/69 2274/70 2274/71 2274/72 2274/73 2274/74 2274/75 2274/76 2274/77 2274/78 2274/79 2274/80 2274/81 2274/82 2274/83 2274/84 2274/85 2274/86 2274/87 2274/88 2274/89 2274/90 2274/91 2274/92 2274/93

Component = 1134/-1

Connector = 3

Headend = 2382/-1

LineupType = 1

RFChannel = 3

RecieverNumDigits = 3

SignalType = 5

TunerDigitDelay = 150

UnattendedTunerDigitDelay = 800

VariableBitrate = 1

}

[TiVo [p0] /hack/guide]#



If I press 3 a zero shows up on the VCR,

If I punch in 333 then 3- shows up on the VCR



I need to figure out how to send 01,02,03,06,32,33 to the VCR L



Not sure where to go from here

I have adjusted RecieverNumDigits to 3 and to 2 and it doesn’t seem to have a great affect

I have adjusted TunerDigitDelay to 50 and to 200 and it doesn’t seem to have an affect



Any ideas?