I ran it as you asked and got :
[TiVo [S3] ~]# rw
File system is now READ/WRITE.
[TiVo [S3] ~]# dos2unix /etc/tclient.conf
dos2unix: converting file /etc/tclient.conf to UNIX format ...
dos2unix: problems converting file /etc/tclient.conf
still don't have networking
Open to any suggestions. I hope I don't have to redo the disk
Also, I was unable to do the full PPP and thats why I used Hyperterm. I didn't seem to get an incoming on the tivo bootup. My network is setup so that my linksys router will give out 2 DHCP addresses and then sets the IP for the remainder IPs based on what I have setup with them (through Tomato firmware). I am not sure if this caused my PPP to fail. I tried both setting an IP address and then using DHCP on the incoming connection but was unsure whose IP I was dealing with, etc.
Last edited by JustinD; 08-10-2008 at 12:03 PM.
Justin
TivoHD w/1tb "update"
TiVo SVR2000 unit w/200Gb Seagate, Turbonetcard & Dlink-810 wireless bridge, FTA Strong STB. Latest image 1.6.###
Bookmarks