Ok, I've had a few goes at getting the codes.
I have attached a zipped tcl for you to try.
Unzip the tcl file, then upload it to your TiVo
Telnet into your tivo and go to the directory you uploaded the tcl to.
Then type the following:
tivosh
{you should now have a prompt like this}
%
Then type
source Austar.tcl
Then type
Austar
Then type
exit
Now find your source record, use TivoWeb(or TivoWebPlus), click MFS(or more... then MFS in TWP) Scroll down the page to "setup" Click the number in the third column (Id). Write down the number that appears after "source =", should look a bit like XXXX/YY ( with numbers in place of XXXXX & YY and may have more or less digits than the X's and Y's shown).
execute the following from Telnet
dbsetx XXXXXX/YY CableBoxCodeNum 29997
Where XXXXXX & YY are from your source.
If successful It should display the current setting and what the new setting now is.
Then reboot your TiVo and test the tivo remote. Make sure initially that the STB faces the TiVo. Once the codes are sorted you can play with final positioning.
Let me know how these codes go. I'll hold on to the remote in case there are still issues.
Peter.
Bookmarks