Originally Posted by
auren
Thanks for the clarification DJC.
followed by the "Almost there a few more seconds please" then the screen goes blank, and thats your lot - no oZTiVo or CacheCard splash screens just 10 minutes (thats when I gave up) or more of inky blackness.....
Thanks guys.
Are you using Scart as the output to your TV? If you use the remote on the Tivo with the sound up can you hear the sound effects when you press the buttons on the remote, i.e. press the Tivo button, or guide button, left or right on the navigation circle.
If so then it is fine however the output is not showing on the TV.
I found on some installs you need to use RF out on the Thomson to your TV, then tune your TV into the Tivo output signal channel by searching from your TV channel setup menu's, this for the initial guided setup.
Then after guided setup you enter the Tivo "Messages and Settings menu --> Recorder and Phone settings --> Scart Settings" In this menu you need to select "RGB + PAL" some TV's need this to accept the Scart signal from the Tivo. You can also change the RF output channel from here.
You then need to enter your Sky digital box's menu system, default password is "0000" and adjust the output of the Scart to RGB..
You may need to adjust some of the other scart settings on the Tivo to get it to work correctly, but try the above first.
TiVo Series 1 Thompson PVR10UK Unit, Dual 250Gb, 512Mb Cachecard, NZ Emulator Port 8000
TiVo Series 1 Sony SVR2000 unit, Dual 300Gb, 512Mb Cachecard, Philips FTA Tuner, NZ Emulator Port 80
TiVo Series 1 Philips unit, Dual 160Gb, Turbonet, FTA Tuner, Private Emulator
TiVo Series 1 Philips unit, 120Gb, Turbonet, Dev Emulator, Development Unit...
DTiVo Series 1 Philips DSR6000 unit, 120Gb, Turbonet, Work in progress...
Bookmarks