IR code for Austar ATB G3

I now have the remote.

My spare TiVo is busy with fault finding the last remaining installer issues in the new oztivo iso release, but should be able to get on to it this weekend.

Peter.

Ok, I've had a few goes at getting the codes.

I have attached a zipped tcl for you to try.

Unzip the tcl file, then upload it to your TiVo

Telnet into your tivo and go to the directory you uploaded the tcl to.

Then type the following:

tivosh

{you should now have a prompt like this}

%

Then type

source Austar.tcl

Then type

Austar

Then type

exit

Now find your source record, use TivoWeb(or TivoWebPlus), click MFS(or more... then MFS in TWP) Scroll down the page to "setup" Click the number in the third column (Id). Write down the number that appears after "source =", should look a bit like XXXX/YY ( with numbers in place of XXXXX & YY and may have more or less digits than the X's and Y's shown).

execute the following from Telnet

dbsetx XXXXXX/YY CableBoxCodeNum 29997

Where XXXXXX & YY are from your source.

If successful It should display the current setting and what the new setting now is.

Then reboot your TiVo and test the tivo remote. Make sure initially that the STB faces the TiVo. Once the codes are sorted you can play with final positioning.

Let me know how these codes go. I'll hold on to the remote in case there are still issues.

Peter.

I have also attached a different version, which uses the same frequency as the 30017 codes.

Let me know how they go.

Peter.