PDA

View Full Version : Failed Connection in Guided Setup / New Server



gideon_friedmann
03-06-2010, 05:55 PM
Hi,

I am trying to run the Guided Setup again in order to change my channels setup.
(I am using the Tivo as a VCR in Israel, but when setting up, I made the mistake and
chose an area with very few channels I need many more now).

I can connect to the Tivo without trouble using telnet (it's over wireless).

However when making the phone call after "connecting" I get the message
"Failed. Service unavailable."

More info:
I remember when setting this unit up with a new image, I chose the server in
Netherlands. That was a serious mistake on my part, and I would like to change back
to the OZ server. How do I do that? Could it be that the server in the Netherlands is
down?

Thanks,
Gideon.

gideon_friedmann
03-06-2010, 06:57 PM
Hello again,

I am now in deep trouble...
I restarted the Tivo, but I cannot receive any signal from my cable box.
The Tivo thinks there is no signal.
I double checked the "Connector" parameter, via the MFS and it shows 3,
which is composite and correct.

Any ideas if the fact that I got stuck during the Guided Setup while connecting would
prevent me from returning to normal settings?

Thanks,
Gideon.

petestrash
03-06-2010, 10:48 PM
It may not be seeing the correct TV system, did you change to PAL guided setup mode?

See here (http://www.oztivo.net/twiki/bin/view/Install/RedoGuidedSetup).

Peter.

gideon_friedmann
04-06-2010, 03:04 AM
I changed back to PAL via the tivoweb .
In Tivo web, the current status says:
Current TiVo Boot Parameters:

root=/dev/hda4 runideturbo=false TV_STD=PAL

Anyway, I think I should better address the original issue, and this will
be solved anyway.

I think a fist simple step would be to make sure that I am addressing
the correct server.

Thanks,
Gideon.

gideon_friedmann
14-06-2010, 09:32 PM
Just to close off this thread.
With no solution, I resorted to a new installation of the OZTivo image.

I am now connected to the OZ server and all is well (in this respect).
Thanks,

Gideon.

petestrash
14-06-2010, 10:31 PM
Ok I'm glad you got it sorted.

Sometimes it is just easier to start from scratch.

Peter.