PDA

View Full Version : Turbonet config on a NZ image



Darren King
15-08-2008, 06:11 AM
Hi all

My turn to ask a question (two actually), which is on behalf of someone I am helping via email:

1. Does the latest NZ image for USA TiVo hardware use the file oztivo.conf in the /etc directory to write the Turbonet configuration settings? If not then where are they stored?

2. Does the configuration file contain the "timing=x" line (where x is a number, usually 3 or 16)?

I ask because the person I am helping is having the classic "Turbonet connected to network is causing lockup" problem and removal of the network lead cures it. I advised to check the oztivo.conf file for the "timing=" line and the reply I got was that there is no such line in that file, which I thought was strange from my point of view as I thought the oztivo.conf file always contained some sort of timing setting entry for a Turbonet configuration.

Adding the appropriate line "timing=16" (for failsafe operation) has made no performance difference.

Not fully knowing the structure of the NZ image I am looking for some advice, hence the post.

Any advice appreciated :)

Wibble
15-08-2008, 03:32 PM
1. Does the latest NZ image for USA TiVo hardware use the file oztivo.conf in the /etc directory to write the Turbonet configuration settings? If not then where are they stored?


The current NZ Image is based on 3.0-01-1-000 (OzTivo 1.5-20051128)

The timing settings will be in the /etc/rc.d/rc.net file.

It should look something like:

if /sbin/insmod -f /lib/modules/turbonet.o macaddr=00:0B:AD:10:10:10 timing=3 ; then
export DYNAMIC_NET_DEV=eth0
/sbin/ifconfig eth0 192.168.1.151 netmask 255.255.255.0 up
/sbin/route add default gw 192.168.1.254
fi

So the oztivo config will be ignored.:)

Darren King
15-08-2008, 06:26 PM
Thank you very much Wibble. That answers the questions, and all things being equal changing the timing from 3 to 16 in that file will resolve the issue (it usually does!).

TyKahu
18-08-2008, 10:33 AM
I ask because the person I am helping is having the classic "Turbonet connected to network is causing lockup" problem and removal of the network lead cures it. I advised to check the oztivo.conf file for the "timing=" line and the reply I got was that there is no such line in that file, which I thought was strange from my point of view as I thought the oztivo.conf file always contained some sort of timing setting entry for a Turbonet configuration.



After numerous e-mails, guidance, and advice from Darren, it was finally resolved when we swapped TurboNet cards. Interestingly, the unit I swapped it into continued to work as well. It looks as if re-seating the TurboNet fixed it.