Results 1 to 5 of 5

Thread: IR Test in setup not working

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #2
    Join Date
    Apr 2007
    Location
    Wellington, NZ
    Posts
    25
    I tried to run it on 2000-Med, just to see what would happen (I got bored), and came back a few hours later, and Tivo was working. I was so ecstatic I threw my arms up as though I had just gotten a wicket (and I hate cricket).

    The bad news is that I'm stuck on the same channel that I started with, unless I use the sky remote.

    I went into setup again, and the IR receiving light on the Sky said it was receiving ONLY when I pressed Channel Down.

    I tried 2000-Slow....but am getting the same thing. On Sky I'm on TV2, but I change the channel up, but I'm still on TV2, though it says TV3 on Tivo. Channel down still registers with Sky, but it doesn't actually change anything.



    ~~~~~~~~~~~~~~~~~~~~~~~~~~~
    And the time is off by 5 hours. Tivo says 2:14pm where as it's really 7:14. I tried guided setup (when trying to get the IR blaster to work with Sky), but no luck with the time. (daylight savings: off....time zone: eastern).
    Last edited by jamesthecarman; 20-05-2007 at 10:07 PM.

Similar Threads

  1. TiVo HD kickstart (self test) codes
    By CheshireCat in forum NZ TiVoHD
    Replies: 0
    Last Post: 06-01-2012, 01:16 PM
  2. Test venue?
    By David Stott in forum New Zealand General Forum
    Replies: 2
    Last Post: 28-09-2008, 04:21 PM
  3. help needed - test call failures
    By red3 in forum Question and Answer Forum
    Replies: 10
    Last Post: 17-04-2006, 06:32 PM
  4. Newbie Setup problem with RF Pal input not working
    By mikepy in forum Question and Answer Forum
    Replies: 31
    Last Post: 24-09-2005, 05:55 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •