Hi Robert
It was an issue with the February release of the beta 1.4 image. The screens were not put in the right spot or something like that. The issue has been documented and images are available from the quote below from the OzTiVo email list (not these forums):
As you can see Minnie (the name of the oztivo website) has the procedure if you wish to try that.To: oztivo email list at www.oztivo.com
Subject: [oztivo] Missing Startup screens for beta Release 1.4 (22/02/05)
As anyone who has loaded Oztivo beta release 1.4 will know, the startup
screens do not show during boot so you do not know whether you are going to
be in maintenance or regular PAL mode until it has finished booting.
I have uploaded the startup screens that I use for this release to:
http://minnie.tuhs.org/twiki/pub/Upl...n2Version7.zip
If you like you can use these as temporary fillers until Ed uploads the
official ones (They do say release 4 instead of 1.4, but at least they work
and it easy for me to see which version is installed).
I have added the Instructions for loading the images and other issues with
this beta release to the page below:
http://minnie.tuhs.org/twiki/bin/vie...ntImageRelease
Feel free to add/change anything.
If you do not wish to install the images then the easiest way is to use TiVoWEB and go into the PAL/NTSC switcher section. If you see GS=0 then you are in normal mode. If you see GS=1 then you are in Maintenance Mode. Typically you will never be in Maintenance Mode unless you have just done the guided setup.
The release of the final image will not have this issue, nor does the V1.3 release of OzTiVo software which has been around for well over a year. There is also a later version of the beta 1.4 image (1st April) than you have used.
Bookmarks