Using Freeview on an STB and having guide data

[inaxeon]

I'm having a little difficulty understanding some aspects of your post, so here's what I assumed

This is handled by dual using input setup.

I assume you mean dual input setup, on my Sony TiVo this translates to the option in Guided Setup called "I have two sources"

You did not mention which postcode, So I have used 02112 as it's the only one that has both sources.

The FTA stuff will be cable.

I'm assuming that 'Cable' is the 'Antenna' input on my TiVo, these channels do show up when using 02112

The add/remove channels to deselecting the ones you dont want does the trick of hiding them [ie. get rid of the suffix (Cab) once the tivo is up and running].

When using 02112 both sets of channels show up in the Guided Setup, So, Using the standard TiVo interface, I have de-selected the channels duplicated on FV from what the Sony TiVo calls the input1 channels (Antenna)

The other input is satellite, you select this and select freeview as the provider.

I did in fact select Freeview as the provider for my input2 (A/V)

There is a special headend for satellite that comes down from the emu separately from the others for dual cab/sat setups.

I'm not exactly sure what you're trying to tell me here, possibly referring to the 02110 headend?

This is the setup I have running on a US 3.0 tivo, local FTA channels + satellite provider.

I am using the 3.0 image (rel 1.6.2) on a Sony SVR-2000

Good luck.

Luck does not appear to be with me on this one, after performing this, I have the FV channels, but the only channels with Guide Data are the ones on input 1 (antenna) the FV channels remain Guide Data-less.

After performing the above I also did a "Clear Guide Data & todo list", then forced a daily call just be sure.

[DJC]

Looks to me like you have correct dual source setup .. presume you followed the instructions on oztivo.net ... PM me your tivo id so I can dig further.