no sound through my tivo

**troy** · 23-07-2006, 09:36 PM

Hi i am new and have just set up the tivo with a cache card, all works fine except there is no sound from the channels. i have tested the sound output from the stb teak dv-b300, and thats ok, i can also hear the tivo noises beeps and such.Is there a setting that i havent added?
thanks trokia

**Darren King** · 24-07-2006, 08:12 AM

Hi.

Generally no there is no setting you have missed provided you have only set up the TiVo for one A/V input source, however there are a couple of things that would be helpful to know:

1. Are you feeding in more than one A/V input (ie something else other than the Teac STB) and therefore does this TiVo have the second A/V modification? If it does have you enabled the second audio input via palmod_config?

2. Have you tried booting the TiVo without the cachecard connected and does it then have sound?

**troy** · 24-07-2006, 01:40 PM

Hi
1. Are you feeding in more than one A/V input (ie something else other than the Teac STB) and therefore does this TiVo have the second A/V modification? If it does have you enabled the second audio input via palmod_config?

-JUST one av i/p

2. Have you tried booting the TiVo without the cachecard connected and does it then have sound?
no

I have already cleared everything and now i will re image the hard drive and start the installation again.

if it happens again i will test it with out the cachecard

thanks for the advice

**petestrash** · 24-07-2006, 10:54 PM

While your taking the cachecard out, also have a look at what revision it is.

Versions earlier than V2.2 have been known to cause sound issues in some TiVo's.

Peter.

**troy** · 25-07-2006, 09:33 PM

hi just to add some info i have
TiVo Philips Series one unit w/250Gb,Seagate 512Mb Cachecard, teac STB
I have just reimaged the seagate drive, double checked settings - no sound
i have removed ram from the cachecard rebooted - no sound
i have removed cachecard and rebooted - no sound
i have replaced original philips tivo disk with cachecard driver installed -gone through setup again-as last time picking cablebox and the connection as composite l+r video STATUS OK
each time i have done this i have connected an rca joiner from input to output and can hear audio from the STB
Note the tivo sounds fine but the sound does cut in the opening sequence when the tivo is playing with balls, funnels and sled ramps. So still no sound through the tivo with the original drive.
I have since returned the 250G seagate into the tivo with the same sound issue.
what do i do now :confused:
thanks troy

**Darren King** · 26-07-2006, 07:05 AM

Originally Posted by troy

the tivo sounds fine but the sound does cut in the opening sequence when the tivo is playing with balls, funnels and sled ramps.

This is normal.

i have replaced original philips tivo disk with cachecard driver installed -gone through setup again-as last time picking cablebox and the connection as composite l+r video STATUS OK

"Status OK" implying you DO have sound?

**petestrash** · 26-07-2006, 09:36 AM

Originally Posted by troy

each time i have done this i have connected an rca joiner from input to output and can hear audio from the STB

Not sure what you mean by this, do you mean when running GS and selecting a cable box you can hear the sound of the STB through your TiVo, but not once it reboots?

Peter.