Briefly looking at the Palmod source code:
// Setup for tuner input
if (mspType == MSP3410D) {
iicw4(MSP_CHIP, WRITE_DEMOD, MODE | 0x8018); // set device to slave mode...
Type: Posts; User: catdog
Briefly looking at the Palmod source code:
// Setup for tuner input
if (mspType == MSP3410D) {
iicw4(MSP_CHIP, WRITE_DEMOD, MODE | 0x8018); // set device to slave mode...
Yes, exactly the same although it requires both 12V and 5V.
One step ahead of you - it autodetects the sound standard so should work in Australia as is!
Sorry for the delay on updates - schematic now attached!
I ran into an issue that the default settings for the STV8216 were all fine - except the outputs are muted on startup! The tivo I2C bus...
I have managed to source the ICs from a contact in Taiwan who had 5 in stock rather than using NZ distributors, allowing me to make sure a prototype works as expected before buying in lots of 25. ...
Effectively that is what I am doing, but the default reset settings of the ST part should decode the NICAM without having to program the chip each time the tivo boots. I agree that a second Micronas...
I am looking at building a NICAM decoder for the Philips/Sony SA tivos to use in New Zealand, similar to the "Mark 1 stereo decoder" used in Australia. The tivo will need to have a PAL tuner fitted...